DynDNS DDK-1500 Especificaciones descargar pdf (Pagina 10)

2.2 Flank Panel

-- Left Flank Panel -- -- Right Flank Panel --

123

6 7

1. Lens Mount: This IP camera is used with either a C or a CS mount lens.

2. DIP Switch:

1. AES: Auto electric shutter.

2. DC IRIS: Use an auto iris (DC drive)

3. DHCP: Turn On / Turn Off to use the DHCP protocol. If the switch points

upwards, the device can change the setup of network function

(enable/disable) via the network.

4. STATIC IP: If the switch points down, the device can’t obtain an IP address

from the DHCP server. This option is needed to configure the

network communication settings.

3. ALARM I/O: This is a 6-PIN connector including the ALARM IN/OUT, ALARM RESET

and GROUND items for connecting with external devices.

 RS485 pin: D+

 RS485 pin: D-

 GND: Ground Contact.

 ALARM IN (INPUT): This is an alarm input which can be programmed in the menu

system to Normally Open or Normally Closed. ( )

 ALARM OUT (OUTPUT): This is an alarm-output trigger. Connect this to external

devices such as buzzers or lights. ( )

 ALARM RST (RESET): This pin connects to an alarm-clear device for clearing an

alarm. ( )

4. RESET: Recover to factory default.

5. 5pin MINI USB Port: The user can use a USB device cable to connect the IP camera to

the USB port on the PC.

6. ALC VR: Iris control VR.

When an auto iris (DC Drive) lens is used, this VR is used to adjust the iris for different

lighting environments. Adjust the VR clock-wise to open the iris and counter-clockwise

to close the iris of the camera.

7. IRIS: Auto iris connector.

This camera works with a DC drive auto iris lens. Please refer to the pin assignment

marked on the camera when connecting the auto iris lens.

0V(Active)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 106 107

Sin comentarios

DynDNS DDK-1500 Especificaciones Pagina 10